Milling Vise – Fixed Base

Code KAFMVF01 KAFMVF02 KAFMVF03 KAFMVF04 KAFMVF05 KAFMVF06
Size 2″ 3″ 4″ 5″ 6″ 8″

Features

  • Tilt Lock Machine Vice design is beamlike with two vertical and horizontal rails connected to the base.
  • You can hold piece parts in the most immobile state possible

Quality

  • Totally enclosed toughened Screw.
  • The bed is guaranteed flat and parallel .0001 per inch.
  • The movable jaw will not lift off the bed
  • The body is rigid and a minimal amount of bending stresses are created in the clamping area
  • There is a minimal deflection of the stationary jaw

Construction

  • Graded Cast Iron dully stress relieved body. Tool steel hardened & ground Jaws.
  • In addition to the rigid design characteristics, a large heavy nut is drawn up against the machined ways on the inside vice as the movable jaw is drawn down. This creates a heavy mass of material under compression and extremely resistant to bending stresses. 4 Jaws Plate positions allowing extra capacity with the jaw plates in the outside position.

Building Your Business

We are here be to be an extension to your company, so that we may both be successful together.

GET A FREE QUOTE

Only takes a few seconds!